1. DisWay Wash: located in the "Station menu" under "Maintenance." Should be performed every 2-3 days to clean the waste line to prevent clogging.

• With a lint free swab and Hilord's Analog Solution, clean the rubber wiper, and then manually push the wiper back to its original position.
• Fill each head's capping station with Hilord's Analog Solution 3-4 times.

HEAD AND WIPER MAINTENANCE

1. Carriage Out: located in the "Station menu" under "Maintenance." Should be performed each morning, between large prints, between rolls, after the work day (if printing over night), and as needed.

• With a lint free swab and Hilord's Analog Solution, clean the rubber wiper, and then manually push the wiper back to its original position.
• Manually slide the carriage to the right until the heads are visible for cleaning.
• Using a lint free swab and Hilord's Analog Solution, gently wipe any ink build-up surrounding each head. DO NOT WIPE THE SURFACE OF THE HEAD.
• Once completed, perform a "Normal Cleaning."

2. Cleaning type [NORMAL]: press [test/cleaning] button located on the control panel twice.

• Should be performed after the "DisWay Wash" and "Carriage Out" maintenance and as needed.
• It is recommended to do this between prints if heavy prints are done and when rolls are changed.
• Strongly recommended to never use the [STRONG] cleaning cycle.
  

AUTOMATIC CLEANING SETTINGS

1. Int Wiping: located in the "Maintenance" menu. The "scan count" setting should be set between 50-100 for text applications, and 20-50 for image applications (heavy coverage).

2. Sleep Clean: located in the "Maintenance" menu, should be set to [4 hours]. This setting will have the plotter automatically run a [NORMAL] cleaning every 4 hours.